Electronics Forum | Thu Nov 03 16:57:16 EDT 2022 | spacecase
I did clean the nozzles, but some of them are older so I will check and swap out with better looking ones. Thank you for the response, troubleshooting seems to be the main part with these things
Electronics Forum | Thu Nov 03 11:31:51 EDT 2022 | proceng1
You described cleaning the spindles and filters, but did you clean the nozzles? Perhaps you got some paste on the nozzle. Also, did you perform the vacuum and blow off testing? Make sure your solenoids are working properly. Is it all 6 heads that
Electronics Forum | Thu Nov 03 02:16:55 EDT 2022 | spacecase
Hey I'm having an issue with a samsung 421f component placer. The machine is fine on the first 5 boards then on the 6th or so it just throws them wherever. The problem is the smallest flat components start sticking to the nozzle even after hitting th
Electronics Forum | Sat May 18 22:51:35 EDT 2002 | yngwie
First of all, my Customers can be described as a real "Jack-Ass" or at least the SQE does. They don't treat us as their partners OR more like "do what I said...When I started to use solder paste you probably weren't borned yet and/or probably still o
Electronics Forum | Tue Dec 16 11:41:26 EST 2008 | fredc
I think fuji and all the after market suppliers use stainless "hypo" tubing for the tips. It is made from 304 stainless which is normally nonmagnetic. In the process of forming this tubing to the hypo specs it is work hardened to 3/4 to full hardness
Electronics Forum | Tue May 25 11:31:57 EDT 1999 | Scott Cook
| | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing
Electronics Forum | Tue May 25 12:19:55 EDT 1999 | M Cox
| | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, bl
Electronics Forum | Wed May 26 10:00:03 EDT 1999 | David Scott
| | | | | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcoh
Electronics Forum | Tue Sep 21 07:47:31 EDT 1999 | Wolfgang Busko
| | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are
Electronics Forum | Fri Sep 07 14:09:57 EDT 2001 | aqueous
Hi Carol, Pressure requirements have changed over the past few years. In the recent past, aqueous cleaning systems relied on high flow, low pressure �flooding� techniques. 20 � 30 PSI pumped through large orifice nozzles. With ever increasing boa
