Electronics Forum | Thu May 20 07:52:36 EDT 2010 | rgduval
In general, cleaning with deionized water is acceptable for most component. Open switches and contacts, in general, do not get damaged in this process. A good drying is required, of course, after washing. However, you've described dewetting issues
Electronics Forum | Fri Aug 06 08:38:25 EDT 2004 | Bob R.
You don't mention the board surface finish, but BGA's on NiAu are prone to brittle fracture in the Sn-Ni intermetallic on the board side of the joint. You may not be able to see it visually, but it would show up in a cross-section. In-circuit test
Electronics Forum | Wed May 19 19:46:41 EDT 2010 | jry74
I am experiencing sporatic de-wettting issues, so I have been thinking about ways to clean fully assembled circuit boards that have open switches, contacts, etc. I also suspect that that plastic bodied components have residual silicone mold release
Electronics Forum | Sun Jun 10 23:49:17 EDT 2001 | Robert Sykoh
No-clean is definitely a cheaper process. It will eliminte cleaning. Some issues associated with no-clean are: -- the flux stain left behind on the PCB will create a cosmetic issue. You may want to seek advice from your customers. -- next, the flux
Electronics Forum | Tue Aug 27 08:13:29 EDT 2002 | mk
Our company uses a conveyorised aqueous cleaner to wash printed circuits after water soluble solder paste is reflowed. The system is closed loop with carbon and resin filters. The water eventually will get dirty. Can it be dumped? Treated? How do y
Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Thu Sep 14 19:44:25 EDT 2000 | Brian W.
I cannot give references to papers, etc, but I can tell you from experience that High Impedance circuits and High Power RF circuits are not something to try no-clean on. For an aerospace customer, I had a circuit that any residue left between two pa
Electronics Forum | Tue Jan 02 14:12:23 EST 2001 | Dave Miller
I work for an R&D company that is starting to do some prototype and limited production circuit cards. We are deciding how we want to build these boards, and we are wondering what we should do about flux and cleaning. We have circuits that run at 15
Electronics Forum | Fri Sep 15 09:24:54 EDT 2000 | C.K.
At my last place of employment, that was the big reason why nobody (especially the Design Engineers) bought into a no-clean process - interference with high-impedance circuits. One guy was so paranoid about flux residues remaining on the board, that
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
winsouce.jpg)
