Electronics Forum | Wed Apr 23 11:28:11 EDT 2008 | jdengler
Did you ask Mirtec? When we were ready to buy a Mirtec they asked if we needed more than normal clearance height. I do not know if this would be retrofitable but maybe you could ask. Jerry
Electronics Forum | Fri Jan 07 16:30:53 EST 2022 | tey422
I have a quick question, what's the tallest (highest) SMT part you ever encounter? 1.5 inch or more? I have to set a depanel router's clearance height. It would need to recalibrate again every time if the spindle or camera's height is adjusted. There
Electronics Forum | Wed May 03 12:10:20 EDT 2006 | jax
Most, if not all, DFX guidelines are Equipment dependant. You can provide standard requirements in your DFX guidlines (edge clearance, component keep-out, height restrictions, etc...) along with an exceptions report for increased cost. just a though
Electronics Forum | Tue Feb 04 08:20:18 EST 2003 | roertner
This rule is very conservative depending on the epoxy you use and the subsequent handling of the board prior to reflow. You should use lead to pad contact area. Also be sure to look at part height and clearance on your flowsolder machine.
Electronics Forum | Wed Jun 29 17:56:47 EDT 2005 | Ryan
We have a new Heller 1809 EXL reflow oven and when we run MELF�s or Aluminum Electrolytic Capacitors through the oven they are being blown off the pads. I have verified that the placement is good before reflow. I verified that they are pushed down
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Fri Dec 27 16:12:54 EST 2019 | anteiv
thank you for reply here is picture of the board https://imgur.com/a/i2MfFBw on the bottom are pins/components which height is about 3-4 mm from bottom of the board we had to increase distance of board from nozzle to make clearance and we increas
Electronics Forum | Thu Feb 19 15:17:52 EST 1998 | Bipin Napal
Available immediately. Call Bipin at 416-385-0855 Make: Electrovert Model: 500 CLV Electrical: 440V, 3Phase, 60HZ Manufacturing Date: Dec 22, 1992, and upgraded in 1994 Physical Size: Length 205.5�, Width 55� Heating Zones : 10 Upper & 10 Lo
Electronics Forum | Wed Oct 13 06:20:00 EDT 2010 | costache
Dear All > > I need to check the solder paste > volume inside the PTH at our board,which size is > 440x620 mm.So, I may need 3D inspection > machine,AXI, not AOI.So, does anyone recommand me > which 3D machine is suited to my PCB? Thanks in > a
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
.gif)
winsouce.jpg)
