Electronics Forum | Sun Jan 13 17:09:58 EST 2019 | sarason
Attach a 3V cell using jumper clips to your existing cbpard, then swap out the dieing cell. if you are lucky you may be able to continue without having to find hat floppy disk. You will still need to know the PW: Given that this is basically an old P
Electronics Forum | Wed Jun 12 14:00:25 EDT 2019 | proceng1
We just use scrap PCBs for Oven carriers. You could probably contact your board house and as for just sheets of FR4 to use. I've also used a binder clip at each corner to lift a board off of the mesh belt in a pinch.
Electronics Forum | Mon Jul 08 15:20:12 EDT 2019 | daniel_marquette
Steve, all the worn carrier clips (chipped, spring less or damages, etc.)have been changed for working ones. Alignment has been performed to loser and afterward thighter tolerances than the manual recommend to see if it changes anything (no). I check
Electronics Forum | Mon Sep 14 22:59:42 EDT 2020 | kylet
Looking to power up this board with 3v coin battery. I've tested this board with it and it works but to solder this on or make something that has clips for the attachment to power this up. Positive and negative connections are the circles on the inne
Electronics Forum | Fri Mar 22 12:29:25 EDT 2019 | unisoft
Unisoft ( http://www.unisoft-cim.com / 203-913-0782 ) has software that should help. Here are some links: *** Assembly Cost by Component Span Report for Quoting *** Assembly Cost by Component Span Report for Quoting http://www.unisoft-c
Electronics Forum | Tue Feb 15 19:54:48 EST 2000 | Clarissa Ortner
I am supposed to heatsink a Temp sensor with leads .9-1.1mm(.035--43"). I have found on our engineering units that the smallest heat sink I have found commercially is still too heavy for the leads and unless the operators use exxxxtreme care the wei
Electronics Forum | Thu Nov 30 21:35:57 EST 2000 | Dave F
So, what's a clip lead? We've got two technologies 1 Surface mount 2 Pin through hole Major categories of pin through hole leads are: * Axial Lead Components have all of its lead wires extending from a component or module body along its long axis.
Electronics Forum | Tue Feb 15 19:54:48 EST 2000 | Clarissa Ortner
I am supposed to heatsink a Temp sensor with leads .9-1.1mm(.035--43"). I have found on our engineering units that the smallest heat sink I have found commercially is still too heavy for the leads and unless the operators use exxxxtreme care the wei
Electronics Forum | Mon Jun 21 16:36:54 EDT 1999 | John Thorup
| | | Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of ass
Electronics Forum | Thu Jun 24 14:14:25 EDT 1999 | Chris
| Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of assembl