Electronics Forum | Thu Jan 09 21:12:18 EST 2020 | nizar
Hi, For the invisible nano coating, do we have any rapid method to determine nano coating worn out on stencil.
Electronics Forum | Mon Mar 21 09:23:34 EST 2005 | sforman1
Some UV cure coatings do not have the correct rheology for sticking to small sharp corners. 984 is one of them. MicroCoat Technologies, Allen, TX makes one that works every time.
Electronics Forum | Fri Jul 23 03:25:43 EDT 2010 | cobar
Please wash the PCB`s before conformal coating.Do you use deodrant before or after you shower??????
Electronics Forum | Fri Jan 25 12:23:07 EST 2013 | dontfeedphils
By "they've been through the wash cycle twice" what do you mean? What kind of cleaning process do you use? What sort of chemistry? How do you handle the assemblies after wash and before coating? Do the operators where power free gloves? -Phil
Electronics Forum | Wed Feb 23 10:01:00 EST 2005 | frankracine
Dave, Few questions concerning your Umiseal 1B73. To cure your Acrylic coating do you respect specification ( 2Hrs-170degree F) or you go faster than that? What do you use to cure it? Do you have to clean your nozzles each day or each monday beca
Electronics Forum | Thu Feb 17 10:33:53 EST 2005 | Frank R.
I use conformal coating DYMAX #984-LVUF and I don't know if it's a problem of viscosity but 0805 components are not covered properly. We use a dispensor to applied it and we cured it by UV. Even if I apply a thicker layer, the coating seems to have
Electronics Forum | Thu Jan 30 15:41:52 EST 2003 | MikeF
The easy part is to determine which parts should be coated. The harder part is making sure the parts that should not be coated do not get coated. I don't even want to think about the amount of labor and materials I've lost due to conformal coat get
Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
Electronics Forum | Mon Feb 09 09:00:17 EST 2015 | jax
Outside the MSD issues stated already (and I cannot provide a exact time not knowing multiple factors like Humidity levels, temps, exposure times, etc...) OSP might be the very worst finish to use in this scenario of side 1 / store on a shelf / side
Electronics Forum | Sat Jul 24 10:20:15 EDT 1999 | Bob Willis
PCB Solder Finishes Survey Questions 1999 Results for the 1996-7 survey are located at www.smartgroup.org As a number of SMART people have requested an update on the solder finishes survey SMART Group have run in the past here is your opportunity t
1 |