Electronics Forum | Sun Jan 18 09:38:34 EST 2004 | m_imtiaz
we are facing cold joint problem in selected component please advise me possiblity of this problem imtiaz
Electronics Forum | Sun Jan 18 10:13:59 EST 2004 | davef
Materials added to solder can change its appearance. For instance: * Gold in tin/lead solder is dull / grainy * Palladium in tin/lead solder is dull / grainy We do NOT advocate using visual appearance to define the appearance of a good and a bad so
Electronics Forum | Mon Jan 19 14:54:38 EST 2004 | cyber_wolf
How did you come to the conclusion that you are having a cold joint problem. Just by appearance ? As Dave stated if you have any of the metals that he listed in the joints they will appear to be dull and grainy sometimes. But... Dave, I will have t
Electronics Forum | Thu Feb 08 08:15:28 EST 2007 | tjcrume
I have received 10 customer returns for a cold solder joint on 1 lead of a 36 pin IC. Everytime it is on the #18 pin. The process is reflow and I can't figure out why the one leg is cold and the other legs look OK.
Electronics Forum | Thu Feb 08 08:20:52 EST 2007 | mzaboogie
tjc, Is this pin connected to a heavy conductor or ground plane? Chris
Electronics Forum | Thu Feb 08 08:33:08 EST 2007 | jdumont
Most likely ground plane stealing your heat. Increase dwell slightly if you can.
Electronics Forum | Thu Feb 08 09:41:23 EST 2007 | SWAG
Check the bare board - could also be an unmasked via on the heel of the pad that is sucking solder into it.
Electronics Forum | Thu Feb 08 22:27:45 EST 2007 | davef
What is the measured temperature on: * Pin 1 * Pin 18
Electronics Forum | Mon Feb 12 10:02:18 EST 2007 | rgduval
A little late to the party here, sorry... Has the joint been verified as a cold solder joint? That is, visually confirmed that it looks like cold solder, and, perhaps, xrayed to confirm the solder status? X-raying may sound a bit extreme, but you'
Electronics Forum | Thu Feb 08 08:54:56 EST 2007 | jhaviland
groundplane not heating properly.. Is it a J leaded IC? sometimes these get bent slightly in the packaging and sit just far enough off the board to cause solder problems.
.gif)
