Electronics Forum | Thu Oct 20 17:59:39 EDT 2011 | davef
inspection arrow Brady and Shercon are two brand names. People like Digi-Key and All-Spec sell them
Electronics Forum | Thu Oct 20 19:18:22 EDT 2011 | eadthem
Something also to consider is, if you don't need to remove the mark, look in to a uniPOSCA paint markers (water based paint). For us we find the arrows take so much longer than the paint, just poping the cap and dotting the problem and moving on.
Electronics Forum | Fri Oct 21 11:30:56 EDT 2011 | remullis
Thanks I got some coming from BRADY. These will have to be removed. Anyone ever needing the part # its, BIA-RD 2.00 bucks a sheet.
Electronics Forum | Thu Oct 20 12:24:07 EDT 2011 | remullis
Where can I purchase the small RED arrows for component defect flagging? I cant seem to find them anywhere. Thanks
Electronics Forum | Thu Apr 24 23:04:45 EDT 2003 | yukim
I've been struggling with this problem for a while. We have two products: A, which is Ok and B, with tombstone defect (0603 & 0805 capacitor chips). A & B have the same design: pad sizes, separation between pads, components orientation. Both have s
Electronics Forum | Fri Apr 25 08:48:25 EDT 2003 | davef
If what you say is accurate, two thing come to mind: * Pads on the board are incorrect for the tombstoning components. * Profile is different on the individual pads of tombstoning components. We have heard of, but never seen, components [tants] that
Electronics Forum | Fri May 16 13:43:29 EDT 2003 | T.Vick
Yukim, Just another thought (way off the solder paste trail that you've been on so far)....Are the parts similar in thickness? The 4796 and 4797 HSP's have a closed loop function that compensates for variations in component thickness based on fe
Electronics Forum | Thu May 01 17:49:33 EDT 2003 | jym2000
Did you check board orientation into the reflow oven? (The Layout components are the same products A & B?) Regards Jesus
Electronics Forum | Mon May 05 02:37:11 EDT 2003 | gaoliangcheng
Maybe you can check the thickness of the solder mask between the pads. If the highest of the solder mask exceed the pad,then the component which was placed will be unbalanced.
Electronics Forum | Wed May 07 11:32:54 EDT 2003 | Grant
Hi, What brand passive components would you recomend for best quality of construction. We are never sure what's good and what's now, and what at some of the better brands. Regards, Grant
