Electronics Forum | Thu Feb 27 15:13:35 EST 2003 | stockley
Oh dear, I tried not to respond but i couldn't help myself. Stop me if I go off into the woods. My guess, Chris, based on your fleeting reference to GF files, is that your SMT machines are Siemens Siplace. If this is so then package orientation def
Electronics Forum | Wed Jan 23 20:02:46 EST 2013 | darby
MACHINE CONFIG> MOUNT R ATTR. You have the choice of REL or ABS. Until you get these sorted and understand the differences you may struggle a bit with rotations. Should be in the manual. I always ran REL, which means the mount angle is relative to th
Electronics Forum | Thu Feb 27 14:02:26 EST 2003 | russ
Genny you are right on with the differences between suppliers/packaging etc... I am a CEM and you are correct that we pay no heed to cad rotations from our customers/designers. A.V.L./manufacturers P/Ns information specifies orientations and such.
Electronics Forum | Thu Feb 27 11:23:18 EST 2003 | russ
Machine rotation is usually based off of component presentation. for example an SO8 can come in either tape and reel and sticks. In tape and reel the component is presented to the machine with pin one at the lower left corner while the stick will hav
Electronics Forum | Thu Feb 27 11:46:47 EST 2003 | genny
We have struggled with this as well. Basically, we have a consistent rotation for all packages of the same type, but I don't think our rotation has anything to do with the actual rotation that the PnP equipment actually wants to see. I believe our
Electronics Forum | Thu Feb 27 11:05:49 EST 2003 | Chris
Hello, I am the manager of a Drafting department and don�t pretend to know too much about the SMT process. But I am the manager of a CAD designer so I am somewhat responsible for the following issue. So since no one else around here seems to have the
Electronics Forum | Thu Feb 27 14:41:48 EST 2003 | jax
Cad rotation should not change with relation to how the part is presented to the machine. It should only depend on how the part is orientated on the PCB when the PCB is at 0 rotation. There is a seperate field to input part rotation inside a feeder.
Electronics Forum | Fri Jul 24 03:09:14 EDT 2009 | fede
We have one YesTech F1 working and a second one purchased on the way. So far, in my half year experience with it, we check solder and lifted leads with TOP cameras. The only ocations I use side cameras are when I have to inspect odd components that
Electronics Forum | Thu Jan 11 19:52:55 EST 2024 | travishemen
Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the part
Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
.png)
