Electronics Forum | Wed Apr 19 11:50:05 EDT 2006 | amol_kane
Hi BJ, Everyone's favourite answer...it depends! If the volume if large, masking boots will save you both, time and money in the long run. Custom boots are relatively expensive to buy, but they pay themselves over time by savings on masking tape. ma
Electronics Forum | Fri Jul 23 03:25:43 EDT 2010 | cobar
Please wash the PCB`s before conformal coating.Do you use deodrant before or after you shower??????
Electronics Forum | Thu Jul 01 07:31:59 EDT 2010 | muarty
Hi Tim, I would speak to your guys at Indium, as I am sure they have a paste developed primarily for Conformally Coated products which should alleviate your problems. John
Electronics Forum | Mon Jul 26 16:28:49 EDT 2010 | mikesewell
Beyond just the cosmetic dewets reliability is very flux/coating dependent. Don't forget about any touchup or hand soldered parts after wave as well.
Electronics Forum | Wed Jun 30 19:31:40 EDT 2010 | jry74
Tim, try and incorporate an inline wash system. We use one with a surfactant and it cleans the "NO CLEAN" fluxes well. If you dont have an inline system, you can manual clean the boards with an surfactant and IPA. You can also do an ionic contamin
Electronics Forum | Wed Jun 16 11:49:55 EDT 2010 | tim_wright
A customer wants to coat a no-clean assembly to cut cost and cycle time. I know what wave flux I can use to make it work, but the Indium SMQ92J paste we use causes dewets. Any other no-clean pastes out there that play nice with acrylic?
Electronics Forum | Tue Apr 23 11:46:29 EDT 2002 | tombr
Howdy Netter's I was talking with my Paste and Flux Supplier about concerns of conforaml coating over "No-Clean" flux. Supplier informs me that this should not be a problem, but I wanted to poll the industry. 1. Does anyone here conformal coat ove
Electronics Forum | Fri Jun 19 15:17:54 EDT 1998 | Chris Jackson
We are in the process of validating Silicon 1C55 (thermal cure) conformal coating over Alpha LR725 solder paste. I am looking for anyone who may be using this process, or has been exposed to someone who is doing this process. Our concern is with the
Electronics Forum | Thu Jun 25 08:29:34 EDT 1998 | Alan Brewin
HumiSeal 1C55 is used by several of our customers over NO-clean pastes with success. Have you seen anything to cause concern?
Electronics Forum | Fri Apr 26 10:42:28 EDT 2002 | Jim M.
I worked for a telecom company that had sites in the deserts, jungles, mountains and regular built up area's. All boards were built using Aim 291/293 No clean solder paste. (all boards built to Bellcore standard) The boards were coated with Dymax ur