Electronics Forum | Thu Feb 23 13:52:01 EST 2012 | cobham1
We are looking to puchase a table top conformal coating system. Can anyone tell me what to look for and are there systems that wont brake the bank.
Electronics Forum | Thu Feb 23 16:31:09 EST 2012 | hegemon
Could be as simple as a pail full of UR coating and some wire hangars! Conformal coating is brushed on, sprayed on, and parts are dipped too, not to mention the wonderful vacuum process that is paralene. Gotta have a little more info as to your a
Electronics Forum | Fri Feb 24 08:02:22 EST 2012 | cobham1
Our production runs normally are 20 piece builds. We don't what to brush because of the brush marks left behind. Reason we wanted a machine is more control then dipping with a tub and modified paper clips. The other problem we have is the company as
Electronics Forum | Wed Feb 29 14:37:14 EST 2012 | hegemon
If I am not mistaken you can buy Spray cans of Conformal Coating. For the small batch in the environment you are describing, that might be the ticket. A bit pricey material wise, but clean up is a cinch. A little masking tape, and spray away!
Electronics Forum | Thu Mar 01 10:35:06 EST 2012 | duso02
For that low a volume it would be simplest and most economical to just out source the work. If you want, just send me an e-mail and I can give you specific options on what would be best for you., in-house or out-house.
Electronics Forum | Fri Mar 02 11:46:18 EST 2012 | cobham1
I like your idea. Can you send me info my email is bill.capen@cobham.com
Electronics Forum | Fri Feb 24 07:28:11 EST 2012 | duso02
If you are going to coat very low volumes then just spray it by hand. The automated machines just won't be worth it unless you are going to do a very large run. They are complicated, require constant attention, still require masking the board and are
Electronics Forum | Fri Oct 29 17:44:13 EDT 2004 | davidcb
Davef, thanks for inputs. I think your correct, we have since obtained some ionic analysis and sure enough there is relatively high chlorides on the bare pcbs. The toluene is controlled within dip tank / drying system, almost no exposure to workers.
Electronics Forum | Thu Apr 16 10:13:32 EDT 2015 | charliedci
Anyone aware of an acrylic conformal coating that is UV curable?
Electronics Forum | Fri Apr 17 05:39:39 EDT 2015 | sarason
Electrolube has one. http://www.electrolube.com/products/conformal-coatings/uvcl/low_non-voc/ Sarason
