Electronics Forum | Thu Apr 19 07:42:53 EDT 2012 | leemeyer
I just purchased a used Universal Instruments Boardflo conveyor model 5363. It looked like it would be perfect to connect 2 of my Quad 4c machines in line. it came with a SMPI to Smema converter box. I connected the box S1PL and S2PL to what I beleiv
Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch
Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)
Electronics Forum | Mon Oct 10 07:40:33 EDT 2005 | pjc
To make an "L" you use a 90 deg turn unit, a.k.a. "diverter" conveyor, then connect to a straight or linking conveyor. Go to this link to see turn unit: http://www.flexlink.com/wps/public/s/10000/c/29667
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Thu Sep 29 12:56:53 EDT 2011 | leemeyer
Smema is connected and works and the 2 machines will communicate. It seems as though the conveyor wants to see a board eveery 30 secs or so, If the upstream can give it one in this timeframe everything is good. If not it times out and the yellow butt
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Thu Aug 21 10:14:57 EDT 2014 | malard
I know my Sanyo machine is no longer made, and the Sanyo connector has died out, but I have an ASYS TRM-03 conveyor that I want to connect up to it, in the manual it references Sanyo for its output format by adjusting a couple of jumpers. However the
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Tue Aug 09 14:41:32 EDT 2005 | jdengler
I do not know JOT conveyors but I do know other manufacturers. Based on that I do not believe this alone will work: -fixed rail on wrong side probably -sensors for board control in wrong location -smema ports may be to far from where they need to co
Electronics Forum | Wed Jul 17 17:56:38 EDT 2019 | rgduval
Check the MOT board. You can usually swap out the individual MOT boards, and see if the problem moves. If it does, you can isolate which board has gone bad. You can also check the encoder on the conveyor, to make sure that is still working correct
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
