Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Wed Jun 27 13:38:56 EDT 2012 | upguy
Thanks for the information and insights. Our booster is probably getting too hot, even with AC. There is bouncing when we trim component locations. Every so often, while trimming component locations, the x-axis will start to slowly move away (by i
Electronics Forum | Tue Jul 17 10:47:54 EDT 2012 | upguy
As as per your information and photo, we attached two box fans under our booster and attached them to the white XGTS connector. The fans are blowing upward with airflow between the booster board and the back of the machine. We will carefully watch
Electronics Forum | Fri Dec 08 14:35:28 EST 2006 | glynnhamer
We currently are building a pcb that has gold fingers, about 36 in a concave V overall shape from .275 on the outside edge fingers tapering down to .197 in the middle of the 2 inch span that plugs into a shelf connector. These fingers are on both sid
Electronics Forum | Sat Dec 09 08:32:25 EST 2006 | davef
Thoughts are: * Most board fabs have routers that can do this work. Can yours rework these boards? * Scrap the boards and start anew. Someone made a mistake. Cut your losses. * As a wild and crazy guy alternative, buy a router with a 45* bit from
Electronics Forum | Fri Sep 01 11:55:27 EDT 2023 | tommy_magyar
In my previous job we fitted these connectors with bespoke gripper nozzles (ASM/Siplace) from bespoke trays made for these due to the high volume. It also reduces the risk of damaging the component further in case of a reject. However, at my current
Electronics Forum | Mon Jun 10 14:27:08 EDT 2019 | bane016
Hello, The machine reports the connection lost between the head and the server?Is there any idea what can be? I would try first to solve the problem if I can, before I call support... Thank you, Problem solved! The connector was damaged.... Th
Electronics Forum | Fri May 25 15:57:15 EDT 2001 | robert
you should be able to get the force requirements from the connector manufacturer. Both the minimum and maximum forces used in the pressing cycle should be recorded to know the connector is properly seated without excessive force that can damage the
Electronics Forum | Thu Mar 15 17:38:46 EDT 2012 | jorge_quijano
Hello guys, I need your thoughts on this PCB I have, it seems that It was damaged by hit or something, I think there is no big issue because damage is on the corners, but I'm not pretty sure if It could has some other hidden damages, It has few SMDs
Electronics Forum | Sun Mar 06 11:04:19 EST 2005 | jsk
Slot three will not recognize magazine. LED's are lit (green)when inserted into slot three. Magazine works in all other slots. Tried multiple magazines. All gave the same error. Error code = E-MIPR-1 unknown magazine type slot 3 No visible damage t
