Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Wed Feb 12 16:23:30 EST 2003 | russ
I agree with DDave, You have something else wrong! .100 dips with .05" lead protrusion should not bridge (in fact I would think that it would be almost impossible). Tell us about your machine, (laminar flow, A-wave, etc.., size of nozzle, wave heig
Electronics Forum | Wed Feb 12 13:37:22 EST 2003 | dwanzek
I need some input on what good solder thieves dimensions should be. I am limited to solving my bridging problem with solder thieves; all process/wave variables have been adjusted to try to solve this problem. There are several of these connectors on
Electronics Forum | Tue Dec 08 15:19:42 EST 2015 | proceng1
Apply the correct amount of paste for the pad size should work ok, as long as the part starts out in the paste. If you have a reduced aperture and the leg doesn't quite touch any paste could result in non-wetting or insufficient solder issues. I gu
Electronics Forum | Tue Aug 24 21:52:06 EDT 2004 | rose
recently I met one very interesting issue with my board and connector. substrate of the board is copper with immersion silver, pad size is about 3x1mm. we print lead-free paste on the pad, then put the connector on the paste. The board was reflowed u
Electronics Forum | Wed Aug 25 20:48:17 EDT 2004 | rose
Hello recently I met one very interesting issue with my board and connector. substrate of the board is copper with immersion silver, pad size is about 3x1mm. we print lead-free paste on the pad, then put the connector on the paste. The board was refl
Electronics Forum | Thu Feb 14 04:38:43 EST 2008 | marjorie
Anyone knows why BGA fell off sometimes from the board? I was running in a single sided only. I encountered a BGA falling off from the pcb pad. The pcb is ENIG and lead free process. The pads had no solder and didn't looks like having a black pad thr
Electronics Forum | Thu Feb 14 23:37:38 EST 2008 | operator
That is bizarre. I would have to say that you need to do a test on the PCB to test solderability with an iron like mentioned before. If you don't find that the pads are contaminated or masked over lightly and the pads do take solder effortlessly, you
Electronics Forum | Mon Oct 29 16:34:02 EST 2001 | patcope1
I have a custom connector that tends to lift during reflow. The PCB retention tabs and pins are lifting off of the pads on the board and the solder is forming underneath the pads, with no heel or toe filet. Is there anyone out there that can help if
Electronics Forum | Tue Jan 14 11:53:44 EST 2020 | avillaro2020
Hi Phil, thanks. I am successful using the same connector on small thinner boards 2-2.5kg) i cant make it work, tried all kinds of profiles with vapour phase but to no avail. Yes you read it right 4.3-6.3mm pcb thickness and 2-2.5Kg. And it is 44 lay
