Electronics Forum | Tue Oct 06 07:37:01 EDT 2015 | m_imtiaz
can we use same reflow oven for lead free and leaded solder paste, is there any chance of lead contamination in lead-free products.
Electronics Forum | Wed Oct 07 13:15:06 EDT 2015 | markhoch
You can most certainly use the same reflow oven for both leaded and lead-free pastes. Obviously your thermal profiles will be different, as the lead-free paste should have a higher reflow temp. As long as your oven has adequate exhaust and flux manag
Electronics Forum | Fri Dec 17 18:24:39 EST 1999 | Clarissa L. Ortner
We have a new program that is going to require us to add many leads to presently leadless parts. It isn't preferred by we are up against the wall. We will be doing mostly passive caps, resistors and diodes and some LCC's as well. Is there any one
Electronics Forum | Tue Jan 20 10:00:25 EST 2015 | TM
Hello We are currently cleaning stencils from both process (PbSn and lead free) in the same cleaning machine. A customer is concerned about cross contamination of lead between stencils. Is there any test kit or tool that you can suggest to test the
Electronics Forum | Tue Jan 20 16:26:59 EST 2015 | emeto
There are a lot of lead testers out there. Just google it. I personally don't think you will find anything wrong, but for the pleasure of your customers buy one and prove it. I would also check the lead on the squeegees of your stencil printers and t
Electronics Forum | Sun Dec 19 08:05:14 EST 1999 | Dave F
Clarissa: We've all done thing on a limited basis, especially on prototype boards, but this doesn't sound like a limited basis, or prototype boards. (And may be I reading too much into this, we all know the frailities of conversing like this.) Thi
Electronics Forum | Mon Nov 11 10:51:40 EST 2013 | dyoungquist
Are you using lead or lead-free solder? 260C would be good for lead solder but may be a bit low for lead-free. We run our lead-free selective solder pot at 300C although we do not have any pre-heat or top heat, just hot nitrogen blowing around the
Electronics Forum | Mon Nov 11 10:54:05 EST 2013 | mleber
We are leaded only. (Military CM)
Electronics Forum | Fri Apr 16 11:03:35 EDT 2004 | davef
Your copper corrosion is not good. It indicates that you have not done a good job in cleaning. [We assume this is a medium green color, not unlike the color of the solder mask on your board, that is almost like a translucent lacquer; rather than th