Electronics Forum | Mon May 03 18:47:50 EDT 2021 | ttheis
One of our gsm machines has recently started activating the upline conveyor while the machine is working causing boards to double load. Has anyone seen this before or have suggestions where to start before I dig into schematics? Thanks
Electronics Forum | Fri May 28 12:57:16 EDT 2021 | cbart
does it only do this with one assembly or panel config? i have seen this when the sensor shoots through a hole in the pcb/panel. the machine sees the panel come in, but it either overshoots or moves slightly into the open area. if i remember correctl
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Mon Aug 25 15:40:58 EDT 2008 | dyoungquist
I am seeing poor quality solder joints, mostly on 0402 components. The problem is that while the pad on the pcb is getting fully wetted, the solder is not flowing up the sides of the 0402 component, i.e. the 0402 lead is somewhat de-wetting. The re
Electronics Forum | Fri Aug 29 07:39:44 EDT 2008 | realchunks
Slow your conveyor down and see what happens. Your profile looks like you just barely get into the reflow zones you need to be.
Electronics Forum | Fri Jun 15 08:47:18 EDT 2007 | ed_faranda
I by all means, am not an expert on Wave processes. But, our second bottom side zone for our wave is down. My boss said "well the flux looks okay, just run it" and won't give me the machine to properly fix. How many people have a problem with thi
Electronics Forum | Fri Jun 15 12:12:34 EDT 2007 | realchunks
Hi Ed, It all depends on more info needed. How many preheaers do you have in your wave? One, two, three? Are you talking bottom side preheat? What size boards do you run and what type of parts are on it. Typically, preheat does several things; w
Electronics Forum | Fri Aug 29 10:37:44 EDT 2008 | gdzuber
Very interesting problem because it shows how systemic this kind of problem can be. So many variables, right? Firstly, discussions here are similar to everyone's postings, but there are some different observations. The manufacturer��s profile, we t