Electronics Forum | Thu Dec 13 20:52:21 EST 2012 | davef
reflow FROM => products & services
Electronics Forum | Wed Jan 16 10:52:19 EST 2008 | kbhatia
R SMT line flow to a R->L flow after the 90 degree turn. We have some equipment that is R->L and wish to interface to the end of this line. So the flow is oven (with enough air blowers that the 8040 is cool) -> 8040 turnstyle to move LEFT (technicall
Electronics Forum | Mon Mar 20 04:42:34 EST 2006 | magnus_y_carlsson
Does anyone know where i can buy spareparts to JOT conveyors?
Electronics Forum | Thu Dec 07 15:23:21 EST 2017 | emeto
Is that a 3 stage conveyor or a single stage? If it is a single stage, your sensor doesn't work, because your motor is already turning. If the input stage is separate you have two options - sensor or motor. Just check them both for proper functioning
Electronics Forum | Mon Mar 20 11:08:17 EST 2006 | Chunks
Spare parts? Like what? If it's your belt motor, try cleaning out the gear box attached to it. 99% of the time it's the lube in this gear box that dries out and turns to glue.
Electronics Forum | Tue Dec 05 20:55:35 EST 2017 | tristanl
Hi all, We traded our 4c work holder for a transport with another company. Eventing works, except that when I put a board in it does not index. All the other functionality seems ok. The rail width moves, I can eject the board, and it knows it needs
Electronics Forum | Thu May 27 16:23:12 EDT 2004 | davef
Process Trials Procedures. Standard trials are often conducted on reflow ovens by production engineers during product assessment, machine approval or in process set-up. The following trials are also used by machine suppliers during equipment develop
Electronics Forum | Tue Oct 09 20:30:25 EDT 2001 | djarvis
Thank you all for your input. We didn't get the oven and if we did I decided in the short term to just turn it around and run it as a belt mesh oven - the next line we buy runs it's conveyor to suit the oven. Hi to you Marc, it's been a few years. Yo
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
