Electronics Forum | Mon Sep 23 13:08:47 EDT 2002 | dragonslayr
Daan has made a valid point with regards to expertise and use of a machine. Yet I recognize that with advanced technology, trades must occur. A hghly sophisticated AOI unit can and will help reduce overall cost of production. Therefore, a need to ha
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Wed Aug 12 15:16:41 EDT 2009 | isd_jwendell
For a small pick-n-place machine I recommend that you take a look at Essemtec.
Electronics Forum | Tue Aug 11 18:15:11 EDT 2009 | ysutariya
Have you looked into Sipad? They will pre-paste your BGA and other component areas with solderpaste that has an adhesive on it. You can then hand place your components and run through a reflow. Here's their site: http://www.sipad.com/
Electronics Forum | Wed Aug 12 08:41:34 EDT 2009 | dwl
Hand placing 200,000-400,000 components, including BGA's a month does NOT sound like fun....
Electronics Forum | Tue Aug 11 17:36:44 EDT 2009 | dyoungquist
You are looking for a complete SMT assembly line plus possible X-Ray inspection and rework equipment. The 3 components of the SMT line are stencil printer, pick-n-place machine and reflow oven. How small are your components? 0603? 0402? What is the
Electronics Forum | Tue Aug 18 10:17:15 EDT 2009 | grantp
Hi, You don't need X-ray and all that crap. I would get an old MYDATA TP9 or something like that, and a manual stencil printer and a batch oven or a small inline oven. Should do the trick and be very low cost. Should be simple to use as well. Tha
Electronics Forum | Mon Aug 10 15:15:17 EDT 2009 | indity
I have very little knowledge of pick and place machines or assembly, and was hoping someone could give me some advice of where to start looking. I do learn quickly so I am not afraid of challenges or learning through mistakes. I need to produce abou
Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose
Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc
Electronics Forum | Sat Feb 17 21:46:26 EST 2001 | edmo
I am the new user for siplace HS50 for about 3 months, running 24 hours production. I used to perform PM every 2 weeks. I have just changed all the plungers(Alu) and nozzles(904) and some nozzle sleeves due to components high throw-out. The estimat
winsouce.jpg)
