Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Mon Sep 16 00:30:56 EDT 2013 | larrygroves
likely something loose in the z or theta axis. Motor overruns and is corrected but goes too far then gets corrected back. it sets up an vibration and can make a lot of noise. best guess is that the spring is broke in the z rack.
Electronics Forum | Wed Sep 26 15:04:09 EDT 2012 | kahrpr
The QSA30 is basically a Samsung CP40 with a few changes. For an older machine the programming is pretty good. it can do array boards and has an import feature for XY data. Tts been about 7 years since I ran one. Its a pretty solid machine.
Electronics Forum | Tue Jan 21 10:03:27 EST 2020 | majdi4
we wanted to make a benchmark on a glue-laying machine below the components with a well-controlled quantity. we are looking for an XY axis robot, any suggestion please ??
Electronics Forum | Tue Aug 11 20:29:51 EDT 2020 | kumarb
Not sure if you are still looking for this motor but received a reply from Elissa (Shenzhen) overnight. Hello this is Samsung CP40 R axis motor J1301632，STEP MOTOR THETA，103H7570-7024 we have original used only price is 86usd/pcs Thank you Elissa
Electronics Forum | Thu Jun 08 22:54:57 EDT 2017 | palsrvs
Hoping to get help on our Samsung CP40. We are trying figure out what part to replace for a Z height motor alarm detected Error Code 1523. Originally Head 1 was having this error. Swapped out I/O board and Z-Axis control for head one and same error s
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Fri Sep 24 14:05:06 EDT 2004 | jsloot
Is there anyone using a QUAD QSA-30? I am experiencing problems with the Y axis drifting in the positive direction. This can occur anytime from a few minutes to several hours after the problem has been fixed. Fixed means recreating a program from scr
Electronics Forum | Mon Mar 18 09:19:48 EDT 2013 | marcelorotofrance
I can move the axes XYUV just in short steps through the "MANUAL NC" function. The axis encoders seem to work; the readings of position follow the axis movements. However the actual position of the head has nothing to do with the readings at the disp
Electronics Forum | Thu Jun 01 16:46:40 EDT 2023 | assuredtech
We have the following Samsung CP20 spare parts and feeders available, we also have CP40 - CP45 spare parts and feeders available - please inquire. 1.) Fine Suntronix MRK OR4-H Power Supply 24V 16 Amp Output 2.) Y Axis Service AmplifierSanyo Denki PY0
winsouce.jpg)
.gif)
