Electronics Forum | Fri Feb 22 09:10:51 EST 2008 | mulder0990
AJ, You can use 0402 feeders to place the 0201 parts. I would suggest getting the feeders you are going to use calibrated before trying to run the parts. Also, another good idea is to get some 0.4mm tape leaf covers for the feeders. They will h
Electronics Forum | Fri Feb 22 12:51:42 EST 2008 | fastek
Logan- That's good to know as I've wondered what makes the 0201 feeder from Fuji so different $$$ from an 0402 feeder? In that they are both 8 x 2mm feeders is it simply a different tape leaf that is the difference? And is the high price compared to
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Wed Feb 27 15:14:52 EST 2008 | gregf912
Senior, below, is correct. THe narrow view camera has to be upgraded in order to place 0201 components. Also to pick the parts you need the 0201 feeders. These feeders present the part 0.3 mm higher than the standard 0402 feeder. The part pickup heig
Electronics Forum | Fri Feb 22 10:27:03 EST 2008 | fastek
Well I've heard you must get the 0201, 0.4mm tape feeder to place an 0201 component as the 0402 feeder won't do it. They ain't cheap @ $1,000 each from Fuji roughly. Also you will need to get 0.4mm nozzles on your machine. Have you actually done thi
Electronics Forum | Fri Feb 22 13:24:24 EST 2008 | mulder0990
How did I know senior was going to get in here too. Nice to see you again. I figured as much with the height difference, but I do not have the equipment here to test my thoughts. We somehow have our machine dialed in to run the 0201 parts with W
Electronics Forum | Fri Feb 22 08:23:51 EST 2008 | aj
All, I understand that there is a requirement to upgrade the narrow view camera on the Fuji CP642 to place 0201 components - is this necessary ? Also, 1 - What tape package to they come in ? Can you use 0402 feeders? aj...
Electronics Forum | Fri Feb 22 13:17:56 EST 2008 | cyber_wolf
0201 Feeders are a different height than regular 8X2's I have put them on a surface plate and measured them with a height gauge. FYI: They make 0201C (Capacitor) and 0201R (Resistor)Again the difference between the two is height. Also it is CRITI
Electronics Forum | Thu May 18 17:34:06 EDT 2006 | Frank
The Juki tape feeders are mechanically actuated. There is a knock pin on the bottom of the feeder bank that will push up to advance the feeder.
.gif)
.gif)
