Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
Electronics Forum | Wed May 26 04:51:12 EDT 2021 | starsanat
Thank you for your attention. It shows an error on startup too, so it get closed by itself. when I start it manually it shows the above mentioned errors. So I should never open up Mark3 manually right? I'll clean everything up and tell you the result
1 |