Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Thu Jan 18 14:02:51 EST 2007 | geb
Thanks for your help everyone. For some reason it has started working again, without altering the program or settings!!?? So I don't actually know why it has done this. Thanks again, Grant
Electronics Forum | Sat Jan 13 19:34:16 EST 2007 | geb
(Its a flex head) I have made a trial program to determine at what point it stops. This is how it goes: I load the program, push the start button it will zero and pick components with head 1. As soon as it finishes placing head 1 parts it halts wher
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
Electronics Forum | Tue Sep 14 07:44:16 EDT 2021 | bukas
hi James. does this happen with every head or just Z6? Does the head move vertically at all? What ANC holder is selected in setup "Hole position detail"? There should be 4 options for "ANC hole position version". If the machine is CP45FV NEO then ANC
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
winsouce.jpg)