Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Tue Jan 31 03:34:50 EST 2006 | chadnugent79
If you are sure that your part data is correct, have you checked the calibration of Z origin? Are the parts leaving an impression on the paste or is there no indication of an attempted place. How small of resistors are we talking 0402, 0603, 0805?
Electronics Forum | Tue Mar 07 10:43:27 EST 2006 | dougs
The E has a different x-y table setup, i seem to remember the CP6 having rollers and cams to control the z table height, the CP6E has a belt driven z axis. Also i think the CP6E is slightly faster, 44K cph against 40K, still just program it as a CP6
Electronics Forum | Wed Mar 19 15:59:40 EDT 2008 | rmitchell
Hi, I am having some problems with my CP6 placement changing in the Y axis. I had to move all parts by +.12mm this morning. Then after 20 boards the placement shifted too high by about .12 mm The IP stayed the same with the same pcb's and fid coo
Electronics Forum | Mon Mar 24 22:46:53 EDT 2008 | crashoveride
Don't try the mecha check yet unless you know how. have you checked the coupling shaft of Y-axis? If it's ok, take a look at the ball screw if it looks like being scratched or something unusual. Also, observe the movement of the machine if you hear a
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Thu Mar 20 07:58:12 EDT 2008 | cyber_wolf
#1Run a Fuji gold board and see if the problem persist. Is your board clamp slipping? Fid camera tight? etc.. To see if you have a Y axis positioning problem: 1.Put the machine in mecha check 2.Go into Y-axis 3.Place a dial indicator so that the st
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Mon May 06 07:29:41 EDT 2002 | winter
maybe you should check the mechanism .such as the drum with the twenty shaft.and A,B AXIS'S synchronization.and the clearance fo the helical gear.check the cutter and no strange sound, check the lens and no dirty or stable.check the twenty shaft.
