Electronics Forum | Thu Dec 27 17:13:02 EST 2007 | mee13
The CP643 has a 0201 camera and a dual board loading system
Electronics Forum | Tue Oct 02 10:26:17 EDT 2012 | jimmyboz
If I had a choice I would choose a CP642 90% of the time. The loading system on the 643 can load 2 PCBs at the same time but is complicated. If 2 seconds on PCB load time is critical on your production choose the 643, if not, choose the 642.
Electronics Forum | Wed May 01 12:33:36 EDT 2019 | cyber_wolf
Depending on what you are doing, feeder cost usually outweighs the price of the pick and place machines. I have worked with almost all of the Fuji CP turret machines. I haven't touched any of the new stuff but I have seen it in person and it is impr
Electronics Forum | Tue Jan 01 22:50:53 EST 2008 | fastek
To get beyond the 36,000 cph threshhold the turret manufacturers had to focus on ways to get the boards in and out of the machine faster. This also included loading more boards inside the worknest. The end result in Fuji's case (CP-643), was a table
Electronics Forum | Thu Jul 26 10:02:46 EDT 2018 | cyber_wolf
Load part on 0201 feeder Install .4mm nozzles in machine Load program and press start button. Feeders, nozzles and machine must be within factory specifications.
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Wed Mar 20 10:17:54 EDT 2013 | cyber_wolf
Don't have a CP7 but I think it has the same loader as a CP643. There are about 15 different sensors that have to be made for the loader and carriers to work properly. Are you doing dual board load ?
Electronics Forum | Sat Aug 19 08:01:39 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
Electronics Forum | Sat Aug 19 08:14:25 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
Electronics Forum | Fri Jun 15 09:52:35 EDT 2007 | cyber_wolf
The proper method is to load a flat plate into the X-Y-Z table. The plate size should be as large as the largest board you run. Indicate the entire area of the plate with a dial indicator. I don't remember the exact spec, but try to stay within .2mm.
| 1 |
.gif)
