15 crown simplimatic 8080 results

Electronics Forum: crown simplimatic 8080 (Page 1 of 2)

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Thu Jan 31 13:20:39 EST 2013 | charliedci

It was fun and easy to be a Chiefs fan 1991 to 1993. Not so much nowadays.

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Tue Feb 05 16:44:35 EST 2013 | rway

Just an FYI regarding the 8080 buffers: When you replace the lithium battery in the display module, replace the one in the PLC as well. Of course, you will need the machine turned on when replacing the batteries.

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Thu Jan 31 13:34:14 EST 2013 | rway

It was fun and easy to be a Chiefs fan 1991 to > 1993. Not so much nowadays. Yes it was. This was the time of Joe Montana's last hurrah. An exciting time to be a Chief's fan.

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Wed Jan 30 16:36:24 EST 2013 | gmcvay6929

Reese, We had that problem a few years back. Simplimatic would not send us any information to fix it. We had to send the controller back to Simplimatic and have them fix the software in the controller. I noticed your chiefs logo on your name. I

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Mon Jan 28 11:22:46 EST 2013 | rway

Does anyone have any experience with these buffers? I have one that has come up with an error message "No PLC Driver." According to the documentation, the issue is the lithium battery in the operator interface. I have confirmed that the battery is

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Thu Jan 31 16:29:26 EST 2013 | markhoch

I had the exact same issue a few years ago at my last place of employment. It happened twice within two months on two seperate peices of Crown-Simplimatic Equipment. I immediately sorced and replaced every lithium battery in all of my Loaders, Unload

Crown-Simplimatic 8080 FIFO Buffer problem

Electronics Forum | Thu Jan 31 10:21:25 EST 2013 | rway

Thanks for the reply. Yes, that is pretty much what I found out. I had to send both the Unicor display and the PLC back to Simplimatic Automation to be reprogrammed. It was the Unicor that lost its memory, but they like to see the units operate to

Simplimatic 8080 buffer issue with dump

Electronics Forum | Thu Jul 18 11:38:18 EDT 2024 | babe7362000

I am trying to figure out why the stacker goes up when you press the dump button. Then I have to lower it by hand to rehome. It then will rehome and go to where it needs to on the 1st slot.