Electronics Forum | Fri Jul 31 10:02:12 EDT 2009 | spitkis2
Thanks for the info. On the Mydata do you position the cut tape inside a feeder or place it on a tray of some sort? Here the environment is OEM R&D lab so a Mydata would be overkill in terms of size and cost. I was thinking of a smaller auto pick
Electronics Forum | Fri Mar 30 11:56:08 EDT 2007 | JD
We have had issues with using the ones from Best. The holes are not always cut correctly and the edges (inside the holes) are not well defined because of the kapton material they use maybe. Plus you leave the mini stencil on the PCB under the BGA whi
Electronics Forum | Thu Sep 24 14:35:12 EDT 1998 | smd
Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. BTW: I'm also looking for conductive
Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Mon Jul 30 16:34:45 EDT 2007 | John S.
We're seeing shorting from the lead of an electrolytic cap to the can. It appears to be solder wicking up the lead, through the boot, and then shorting to the can. Has anyone else experienced this? It is a very cheap cap from China of course, but
Electronics Forum | Wed Oct 01 07:22:11 EDT 2014 | oguzdtas
First all, I am very new about all this stuff so please forgive me if i say anything wrong. We are using a universal vcd axial. We had a problem with cut and clinch. We blieve if we lengthen the wreck material going inside the tubes, the problem wil
Electronics Forum | Fri Sep 25 06:39:15 EDT 1998 | Wayne Bracy
| Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. | BTW: I'm also looking for conduc
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Mar 14 09:58:07 EST 2001 | dason_c
I am not sure that how big of your shield, I am using Metcal Soldering System and modify the Metcal Removal Tip to cut into half. I don't want to use hot air and it may damage the component inside.... Rgds. Dason
Electronics Forum | Fri Jan 20 11:44:40 EST 2006 | Mike Dolbow Atotalgps.com
I have seen 100% Matte Tin plating and a lot of Sn/Ag/Cu plating for gull wing parts. This is the most common type of plating. Also in a lead free process you will see that the very end Toe of the part will not flow. This is due to the metal being cu
