Electronics Forum | Wed Aug 14 17:17:34 EDT 2002 | Benny
I am looking for cmos crystal oscillator data sheet or part number and DC/DC converter of +5V,-5V,3.6V data sheet or part number. I will be happy to recive any answers.
Electronics Forum | Tue Aug 20 17:18:12 EDT 2002 | melo_guy
What specs are you looing for? who is the manufacturer? If you need to find a crystal or oscillator for a project, check out http://www.ecliptek.com. If you have any needs e-mail me at TBart@ecliptek.com.
Electronics Forum | Sat Dec 17 15:58:57 EST 2005 | Mika
We are also interested in this, but where can we find the dimensions? We have thouht about some kind of a guideline to simplify the way of how we do the "Matrix tray numbers" input to our fine pitch machine. We do a lot of prototype production and ev
Electronics Forum | Sun Aug 14 22:58:17 EDT 2005 | crishan
Hi All, I would like help in establishing what is a feasible PPM reject rate from a typical SMD line. As a reference an SMD line consists of, solder paste printer, chip component placement, pick and place IC components and reflow. What is a bench
Electronics Forum | Sat Nov 05 17:46:50 EDT 2016 | sarason
Try Visualplace, http://www.compuphase.com/visualplace/visualplace_en.htm Gerber Viewer, component centrepoint extraction and more! sarason
Electronics Forum | Tue Feb 01 11:34:55 EST 2005 | Dougs
Has anyone heard of any software that can be used to clean up or manipulate x-y placement data. We are a small contract manufacturer with various customers, some who supply good x-y data to component centres and some who supply x-y data to a pin or
Electronics Forum | Wed Jan 25 01:48:47 EST 2006 | ____
There is a manual available that deals with how to create part data files for connectors and BGA's. Contact Fuji America for this manual. REF-SMD3PD-1.1E. There may be a newer version available than the one I have listed. It is also available in PDF
Electronics Forum | Wed Jul 06 09:51:23 EDT 2005 | Jack
Doug, It always seems easier to fix one or two problems by eye at the time. The real problem comes when the customer wants the same board run again later. You're okay if you saved the corrected placement routine, but if you end up moving the job t
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Thu Jan 05 13:29:43 EST 2006 | jax
Nothing is automatic from Gerber. Gerber is stupid data. (Pads are defined, not components) I think you are looking for Centroid Outputs not CAD. Cad defines the components on the board as well as the board itself. Centroid gives Ref. Desig., X, Y,