Electronics Forum | Wed Nov 21 00:14:25 EST 2018 | leeg
As Dekhead has said, sounds to me like you have the wrong setting in your screen choice within the program, is it edge or centre justified?
Electronics Forum | Sun Oct 21 22:05:01 EDT 2018 | srini1904
Hello, We have Dek 248 Icon i2 semi auto screen printer. This machine was not in use for long time and Bios battery was dead. We replaced Bios battery and now date are correct. Issue is its not communicating to control board. Suspecting Bios setti
Electronics Forum | Mon Feb 02 13:09:46 EST 2004 | kauer
Pretty sure. in Y3 enclosure. Page 6.11 in manual VR3 sets the slope of Amp Gain.
Electronics Forum | Thu Oct 26 15:44:28 EDT 2017 | dekhead
Sounds like you need to go into set-up and define HDD. Does not auto-detect.
Electronics Forum | Thu Feb 21 16:53:32 EST 2019 | bane016
I don't know...but at DEK horizont i2 , i3 and ASM have option in machine settings "print/no print....if you check "no print" machine work in passthrough mode...
Electronics Forum | Mon May 05 15:52:22 EDT 2008 | dekhead
Assuming you have the scale that corresponds with Board Width for center justified stencil. Formula would be: 2 x (distance to image {mm} - 368) = Board Width (setting on scale) http://www.dekhead.com/
Electronics Forum | Thu Feb 21 19:48:47 EST 2019 | dekhead
Is Downline FMI set to MIU? Is MIU configured (SW3) for correct interface protocol? Is downline cable pinned out correctly?
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Fri Jan 17 09:17:49 EST 2020 | sumote
Hello all. We recently purchased a DEK Hroizon to replace our aging 265 machine. The 265 had an auto-loading stencil setting known as a "Distance To Image" where it would place the stencil directly over the board. The Horizon 2 has no such feature.
Electronics Forum | Mon Jan 20 03:13:34 EST 2020 | silverlead
Included screenshots from DEK manual, outlining stencil depth adjustment. Basically, distance from rear of the stencil to the front of the image is value needed to be set on scale when positioning stencil. There is an other way to adjust stencil, by
winsouce.jpg)