Electronics Forum | Fri Aug 12 18:39:21 EDT 2022 | magsat
Hello, please help, On DEK 265 GSX I have on the monitor: "Downloading vision system" and then nothing happens (no error comes up)
Electronics Forum | Sat Aug 13 22:55:11 EDT 2022 | dekhead
Most likely an issue with vision system, or communication therewith... But with # of combinations of CPU, Cognex and cameras, would prefer off forum contact to sort it out. email sent.
Electronics Forum | Tue Aug 16 06:20:34 EDT 2022 | bukas
it can be a bad contact with backboard. clean the slot and gold fingers with contact cleaner and push it in and out a few times.
Electronics Forum | Mon Sep 19 11:29:33 EDT 2011 | padawanlinuxero
Hello guys ! I have a problem with a DEK 265 GSX, sometimes after download the vision or during, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE Now for a few weeks it gave me
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Fri Sep 28 21:30:35 EDT 2012 | dekhead
Assuming you are not seeing 240VAC @ PSU inputs. Present @ transformer, but not much beyond CB1 on Y4... Nothing to PSU's or PC, etc. Inrush suppressor(s) (Thermistors). Contact me directly. www.dekhead.com
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Thu Mar 22 10:11:47 EDT 2012 | menatech
if you download the mint program (maintance key switched and download via auto mode. Does is read the card correct and does it identifies the correct motor encoder?
Electronics Forum | Thu Sep 22 20:52:08 EDT 2011 | dekhead
Low DCV on batteries should not cause issue with MINT download, but will cause loss of MINT files (and necessitate reload) upon power down... Please contact me for additional assistance. http://www.dekhead.com
winsouce.jpg)
