Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Mon May 05 08:42:35 EDT 2008 | mmjm_1099
We use double image stencils with our DEK Horizons. My operators would just load the pcb on to the rials and manually adjust the stencil and clamp it. Once they do that they add into the comments what number the handcrank adjustable is at so next tim
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead
Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?
Electronics Forum | Mon May 05 15:52:22 EDT 2008 | dekhead
Assuming you have the scale that corresponds with Board Width for center justified stencil. Formula would be: 2 x (distance to image {mm} - 368) = Board Width (setting on scale) http://www.dekhead.com/
Electronics Forum | Thu Feb 21 13:50:26 EST 2019 | s197seth
I am trying to do a Pass Through and the DEK wont send the board to the Conveyor and it says its waiting for downline transfer even when the SMEMAs are tripped. and on the Multi - Interface Unit, the light next to downline ready is not on. Any help?
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Thu Feb 13 10:38:33 EST 2003 | vortex
While trying to develop new programs for our DEK Horizon 265 we are forced to use pads as vision alignments due to lack of real fiducals, thanks engineering. My question is, Is there any way to narrow the search window when performing a locate fiduca
.gif)
winsouce.jpg)
