Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
Electronics Forum | Thu Jul 16 16:56:02 EDT 1998 | Doug Nebel
| Howdy 2, | I am using my first DEK GSX PRINTER. Looks and acts good so far. Who know what - good, bad, or in between? Just want to get the facts from those who know. | Earl Moon We have had our 265 GSX a little over 2 years. Print quality has bee
Electronics Forum | Fri Jan 05 12:18:10 EST 2018 | dekhead
Does it happen in board stop move in diagnostics?
Electronics Forum | Thu Jan 04 21:38:27 EST 2018 | dekhead
Error is occurring during move to fiducial 1 position (from board stop position)? Or during move to board stop position (from park position)? What is error displaying onscreen? Did you also just replace belt(s)?
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Tue Jul 16 15:58:53 EDT 2019 | rob1
I have entered a value for the "Right Feed Delay" and it resolved the issue. Thank you.
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Wed Aug 31 07:40:58 EDT 2016 | bukas
BIOS stopped loading, now when I start machine monitor doesn't receive any signal. tried to start machine with different hard drive but nothing
