Electronics Forum: dek 265 won initialise (Page 1 of 2)

Dek265MK1 failing to initialise

Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj

machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed

DEK 265

Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632

Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything

DEK 265 Horizon

Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead

I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu

DEK 265 Horizon

Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead

Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?

DEK 265 Horizon

Electronics Forum | Thu Feb 21 19:30:32 EST 2019 | Seth

It won’t pass down regardless

Older gear MPM Speedline Accela VS. DEK 265 Horizon

Electronics Forum | Fri Feb 09 14:28:08 EST 2024 | redspare1

Yes, I have ran into this. They won't even sell you a screw unless you give them money to "register" Trying to start for the lowest cost. I see the DEK could be harder to learn as a new person. Yes, self calibration would be great! Thanks everyone f

Changing a DEK 265 Horizon to right to left

Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead

If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product

DEK 265Lt Vision/Camera?

Electronics Forum | Sat Sep 08 16:02:44 EDT 2012 | processman

hi, We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LED`s flash, cognex card intitialises with no error. The issue is we have no fiducial recognition or image on the monitor. Have swapped out camera, cogn

DEK 265Lt vision issue

Electronics Forum | Wed Feb 14 08:48:57 EST 2024 | andrii

hi, I have very very old DEK 265 Lt And I have a problem that Mr. processman described a long time ago. But no one answered him. Maybe someone can help me now? "We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LE

DEK 265GSX HOOD OPEN ERROR

Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead

No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom

  1 2 Next

dek 265 won initialise searches for Companies, Equipment, Machines, Suppliers & Information