Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Thu Mar 19 07:57:13 EDT 2020 | leeg
Which model of Dek265 is it?
Electronics Forum | Fri Mar 20 03:30:55 EDT 2020 | leeg
Have you tried to Zero the x and Y offset and removed the stencil and re-inserted?
Electronics Forum | Wed Mar 25 11:09:08 EDT 2020 | sumote
Have you measured and input the "Distance To Image" setting correctly? If that number is off, you will get that error.
Electronics Forum | Tue Mar 31 09:25:18 EDT 2020 | emeto
If you believe your picture is in the middle and is not skewed, than go to your basics and recheck your fiducial locations and detection. Sometimes these machines recognize something around and give you this error. Try program with isolated pads and
Electronics Forum | Thu Mar 19 15:28:34 EDT 2020 | emeto
You are programing something wrong or your image is not in the center of the stencil. On DEK machines you can move a lot in Y by offseting the image in the program. In X machine can move +_5mm. Now, sometimes there is a way around this as well if yo
Electronics Forum | Fri Sep 07 17:13:54 EDT 2012 | burb1999
Run the calibration screen/procedure. I have had where the camera was hit etc.. and caused a misalligned print.
winsouce.jpg)
