Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Wed May 16 00:14:45 EDT 2018 | leeg
We have a Dek Horizon and we have started getting a data file open error when trying to save files. This is resulting in us having to re-teach board fiducials etc in every time we switch back to a previous job. Any ideas?
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Wed Aug 31 08:12:37 EDT 2016 | ttheis
Search for the bios or motherboard on ebay. Type in the part numbers you find on the boards and see if anything comes up. Often these are standard pc boards. I've repaired my old MPM by finding the cards on ebay cheap.
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Wed Aug 31 09:35:15 EDT 2016 | dekhead
Certainly possible CPU board issue; but check PC power supply, that all DCV are present and strong. www.dekhead.com
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Thu Sep 01 08:30:54 EDT 2016 | bukas
Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > www.dekhead.com > Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > http:/