Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Fri Jun 04 04:10:52 EDT 2010 | leeg
Have you checked the Rail Lifted Sensor
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Tue Jun 12 17:12:20 EDT 2018 | paul_bmc
I have an issue on my DEK Galaxy printer. The problem is I need to use the hard PCB stop rather than the sensor stop. The printer use to have Heavy Pallet Rails installed prior to me purchasing the machine. The 3rd party removed the rails and repl
Electronics Forum | Sat Jun 05 09:24:40 EDT 2010 | dekhead
As stated, that error relates to rail lifted sensord (L & R)... Machine is perceiving that something is causing rails to lift at inappropriate time. You can monitor sensor status in Rising Table diagnostic to see that they are toggling appropriately.
Electronics Forum | Fri Feb 27 12:06:03 EST 2004 | jseagle
A 20 x 20 frame with the image centered will drop in IF you have a printer with adjustable rails for the stencil, the rails move in and out to accomodate 29 x 29 to smaller than 20 x 20. Otherwise, you will need the adapter. James
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
Electronics Forum | Mon Jan 27 10:37:14 EST 2020 | jede
In what regards? If you are wondering if the gridlock will cause damage to parts on the underside of the board, the concern is using fixed support rails. A company I used to work for fixed this by using pneumatic support rails(I am sure there are exa
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
