Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Wed Jun 04 15:06:35 EDT 2008 | locostpp
Hi Base, I guess your right - due to the complexity of the software we plan on keeping the source code under our control BUT we will not be dongling or protecting it in any other way and we will be publishing the program on our website. We will pub
Electronics Forum | Fri Jan 07 09:23:16 EST 2011 | ercdave1
I removed the front cover of the controller box and found a cable secured to the right plate with cable ties but no floppy. the cable has a 50 pin connector. maybe is an option on your machine that my didnt get. I hope tom has better luck. I am goin
Electronics Forum | Tue Jul 13 14:03:33 EDT 1999 | Earl Moon
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Thu May 14 10:50:14 EDT 2009 | dnachristen
Hello, New to the site here. Have a few questions regarding Philips (Assembleon) Equipment and program transfer. We need the ability to transfer "Golden Programs" to and from the machines. I'm currently using AMS 2.0 with line control. I hooked up
Electronics Forum | Wed Sep 20 19:34:13 EDT 2000 | Dave F
Congrats. You now control the source of almost 70% of the defects of your SMT operation. There is a neat series of presentations on printing, each year at SMI. One of the best of the SMI series was in 1997, because presenters used a common board
Electronics Forum | Thu Sep 09 08:33:07 EDT 1999 | Dave F
| My company is looking to perform "real time" statistical process control on our current SMT operations. I have identified the critical processes for SPC but have not had much luck in finding a system(s) that can monitor the required processes for m
Electronics Forum | Fri Sep 06 11:58:21 EDT 2002 | Brian W.
The most effective method is to monitor both printing results and parameters. Periodically (maybe once per month), run QCCalc or another program to measure the machine's capability to hold its set parameters. I also run control charts on the paste h
.gif)
.gif)
