Electronics Forum | Thu Dec 19 08:26:19 EST 2013 | dekhead
Are both machines running the same type of computer (Advantech Computer w/P3 1G CPU probable)? if not possible problem with system software incompatibility. Contact me directly, I may be able to assist. www.dekhead.com
Electronics Forum | Tue Oct 26 17:30:36 EDT 2021 | dilogic
Messages indicate bad battery on EPC-5 CPU board, not SYS68K CPU-30. You have to fix that first. What kind of hard disk is installed? EPC-5 boards support small disk sizes, so sometimes , if larger disk is used, users "trim" reported capacity to lowe
Electronics Forum | Mon Oct 25 21:42:26 EDT 2021 | astarotf
thanks for the info. But we do not have the installation discs or the software to reinstall the machine. There is no EXM-9 calibration information or BIOS parameters in the document. We have already exchanged the old battery for a new battery on the
Electronics Forum | Tue Oct 26 15:47:09 EDT 2021 | astarotf
Thanks Deni for the document, it is very valuable. I put the configuration that the document indicates to the machine and still the machine does not proceed to execute the SO / 2. After configuring it, we got these messages that I share in the foll
Electronics Forum | Tue Oct 12 15:15:14 EDT 2021 | astarotf
Hello there I am having difficulty starting the GSM2 4688A machine, the operating system does not start and does not read the hard disk. Procedures that we have carried out: 1. We validate the hard drive, it is mounted on an external computer and it
Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
1 |