Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Thu Sep 22 20:52:08 EDT 2011 | dekhead
Low DCV on batteries should not cause issue with MINT download, but will cause loss of MINT files (and necessitate reload) upon power down... Please contact me for additional assistance. http://www.dekhead.com
