Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Wed Aug 07 13:21:58 EDT 2024 | spoiltforchoice
I haven't got numbers for older machines. But for recent models DEK is quite clearly bigger than either a Speedprint/Europlacer or an MPM100. Speedprint/Europlacer focuses on its smaller footprint as a selling point, although it looks to me like a R
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Thu Dec 22 11:18:59 EST 2022 | emanuel
I am interested to know if you solved this problem. We are experiencing something similar. The table is the first node in the CAN chain. As I see the structure, the CAN starts from the Nextmove ES card, goes first to the table driver and continues to
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Sat Sep 13 09:55:05 EDT 2008 | mainenetservices
Does anyone out there know of anyone who can repair the Green firewire camera (Cyberoptics) off the Dek printers. I had 2 go bad and would like to get them fixed if possible so I would have backups. Thanks in Advance
Electronics Forum | Mon Sep 22 11:26:19 EDT 2008 | mainenetservices
Does anyone out there know of anyone who can > repair the Green firewire camera (Cyberoptics) > off the Dek printers. I had 2 go bad and would > like to get them fixed if possible so I would > have backups. > > Thanks in Advance I can repair
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
