Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
Electronics Forum | Wed Nov 21 09:10:11 EST 2018 | dekhead
Are you seeing the stencil operational (changing state) in diagnostics? If sensor works then, look at image justification in product file...
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Fri Oct 25 11:21:05 EDT 2002 | soupatech
This may sound like a stupid question but keep in mind I am very new at this and most of the training I have recieved has been from operation manuals and this forum (thanks to all). Our purchasing agent (new hire) is ordering a stencil for the first
Electronics Forum | Fri Feb 05 02:40:40 EST 2021 | victorzubashev
For components with the large pads, you can also use secondary soldering dispensing. Some printers like DEK have an option to mount a syringe with an auger valve to do dispensing after the printing step process. Obviously will not work if you have to
Electronics Forum | Tue Jun 03 17:53:21 EDT 2008 | pms
Anyone out there using this system ? We have been using the older DEK Vectra system. I don't like it, never did, but do like the small storage footprint, and are stencil supplier is showing signs that this system is gonna be obselete in the near fut
Electronics Forum | Wed Jun 04 12:56:46 EDT 2008 | charliedci
We have been using the the DEK VG system now for 1 yr. Required stencil storage space is greatly reduced and stencil costs are lower. We've had some trouble with stencils not mounting flush in frame, but after a phone conversation with DEK engineerin
Electronics Forum | Wed May 04 11:49:24 EDT 2005 | thomasleetch
Does any one have a picture of a unversal stencil adapter for a SPM printer? We have stencils for Dek machines that are 25" by 23"wide that we need to turn 90 degrees to be able to center the pattern for the spm printer.Or do you have one for sale? T
winsouce.jpg)