Electronics Forum | Tue Aug 23 16:57:29 EDT 2005 | HOSS
50% of seeing it in a single pass. The only time we do this is if we have a board off the line that has delaminated. We'll run a sample of boards through bare to confirm that we have a bad batch. Even if we see no failures on the bare boards, we'l
Electronics Forum | Wed May 07 17:52:36 EDT 2008 | wayne123
I have these boards that are a four layer FR4 material, we had been running them for quite awhile with no trouble, and then they started delaminating, I checked my Reflow oven profile and I was barely hitting the temps required for our paste, we then
Electronics Forum | Mon Jun 08 15:00:08 EDT 1998 | Earl Moon
| I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot
Electronics Forum | Mon Dec 08 17:06:59 EST 2008 | boardhouse
Hi MGL, Couple things to ask, have the boards recently been changed to Rohs builds? STD FR4 to High TD Laminate. Check the stack-up the board houses are using. Just about all Rohs laminate has Resin starvation issues when used in single ply co
Electronics Forum | Mon Jun 08 15:01:02 EDT 1998 | D.Lange
| I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot
Electronics Forum | Thu Feb 14 20:24:07 EST 2002 | scott
My first reaction would be to run! FAST! Flex -- well, it... flexes... and isn't flat. While you assemble it, While you transport it, While it goes through the oven... SMT Connectors typically need to be held down during reflow. Fiducial types are
Electronics Forum | Thu Jun 25 14:41:07 EDT 1998 | Earl Moon
| Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Handb
Electronics Forum | Thu Aug 19 23:56:49 EDT 1999 | Earl Moon
| | I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the
Electronics Forum | Fri Jun 26 15:37:50 EDT 1998 | Justin Medernach
| | | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection H
Electronics Forum | Fri Jun 26 11:27:12 EDT 1998 | Earl Moon
| | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Han
