Electronics Forum | Wed Nov 01 11:53:23 EDT 2017 | spoiltforchoice
Extensive documentation, custom diagnostic tools from the manufacturer and knowledge/competence. Try Louis Rossman on youtube.
Electronics Forum | Thu Jul 05 10:55:45 EDT 2007 | vickt
Daniel, What exactely are you trying to accomplish with this? Do you have a particular communications issue that requires this as a diagnostics tool? If so, there are lots of previous threads on this subject. Have you already referenced the IPC spec
Electronics Forum | Thu Aug 20 08:23:23 EDT 2009 | ratsalad
One diagnostic tool that I have found useful in the past is the "hot plate test". Place suspect components and/or PCB's on a hot plate and turn it on High. Then observe. Granted the conditions on the hot plate are not the same as in a reflow oven,
Electronics Forum | Fri Apr 13 02:35:42 EDT 2018 | kimseo
PROBLEM SOLVED I bought a diagnostic PC card (ISA/PCI) for checking the PC of the machine... Firstly I tried ISA slot - nothing happend.. the diagnostic card didn't work... so I tried to put it into PCI slot but.... what happend ? The machine starte
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Sat Dec 03 08:15:41 EST 2005 | davef
Welcome Here for articles on developing reflow recipes: * http://www.process-heating.com/CDA/ArticleInformation/features/BNP__Features__Item/0,3156,18454,00.html * http://www.smtinfo.net/Db/_Reflow%20Soldering.html * http://www.smtinfocus.com/proc
Electronics Forum | Tue Jul 07 12:50:33 EDT 2009 | davef
First, we don't know dip about nonbalanced squeegee. We clipped the above gif from: Solder Paste Printing Inspection: An Inside Look; E Litman, System Engineer, Orbotech; SMT January, 2004 Second, Tekscan talks about a product: I-Scan force and pre
Electronics Forum | Fri Sep 22 11:51:32 EDT 2006 | chris g
Have you tried doing a short diagnostic test? That will check the repeatability and backlash of the axis. Did you use the C-tool when calibrating the camera?
Electronics Forum | Wed Feb 24 10:57:52 EST 2021 | spoiltforchoice
And then they make a new machine, and start the software all over again, or change the hardware so much the older model doesn't get any of the software tweaks on the new one even if they are supposedly the same model.... Neoden bigger machines shoul
Electronics Forum | Wed Apr 22 15:18:47 EDT 1998 | RNLM
| I would like to know something about Siemens machines from users of Siplace or old machines. | Thanks ! I have found that the SIPLACE equipment is and will be supported more effectively as additional tools are made available for customer use.
.gif)
