Electronics Forum | Wed Aug 17 14:30:58 EDT 2005 | russ
I usually see this with mask that is not fully cured from the PCB shop. This probably agrees with the baking statement that you made.
Electronics Forum | Wed Aug 17 13:57:27 EDT 2005 | ppwlee
We have encountered what appears to be mask discoloration after wave soldering. The areas of concern coincide with the areas that were exposed selectively by fixtures during wave soldering, dominated by one date code of PCB with a slightly different
Electronics Forum | Wed Aug 17 22:41:37 EDT 2005 | davef
Peter are you having fun with solder masks erwat? We saw this years ago with LPI solder masks. It shows occasionally with other masks. We agree with Russ. If nothing [eg, alcohol, flux thinner, acetonitrile, or water] dissolves the haze, then it
Electronics Forum | Thu May 28 15:54:45 EDT 2009 | elmerito
Hello, We have designed a 160ball bga substrate. Now we want to use the same substrate for the 145ball version of the product. All are the same, the package size, ball pitch, solder ball size only the number of balls will change. We will use a new s
Electronics Forum | Thu May 28 22:12:18 EDT 2009 | davef
If your newer board passes a tape test, you should be OK.
Electronics Forum | Mon Aug 21 19:38:33 EDT 2000 | Dave F
Eric: I�ll pass on the uV and ammonia, also. Thoughts are: 1 You�re correct that the temperature/humidity mix can be a big driver to latex peelable solder mask cure time, but don�t overlook material thickness. Dispensers put material in a very th
Electronics Forum | Wed Jun 22 15:03:12 EDT 2005 | patrickbruneel
The only thing ammonia can do is tarnish copper and make it more difficult to solder. And the higher temp in lead-free will discolor the latex (giving it a sticky surface), but the functionality of the mask will be intact. There should be greater co
Electronics Forum | Sat Nov 08 08:16:45 EST 2003 | davef
We saw this quite a bit, I want to say 5 or 6 years ago, but it's probably more like 10 years ago. It's caused by poor solder mask crue. Talk to your board fabricator about solutions.
Electronics Forum | Fri Nov 07 12:48:31 EST 2003 | rholland
I have seen in the last couple of months more boards with a white hazing under the solder mask. I ran a few tests on a board to determine the cause of the white hazing underneath the solder mask. First I confirmed, or at least I think I confirmed, t
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c
.gif)
