Electronics Forum | Fri Nov 27 04:56:36 EST 1998 | Terry Keen
Hi I have been conducting my first reflow profiles. Most of the texts that I have read suggest soldering the thermocouples to a populated pcb. I am finding this very difficult. I have been using a high melting point (Sn5 / Pb95) solder and the diff
Electronics Forum | Thu Jun 14 23:21:30 EDT 2001 | oem boy
I am working on 0201 development for my company in the UK, and I am planning a rather extensive DOE for my reflow oven profile. I am planning on studying various ramp rates, soak times, times above liquidus, peak temps, etc... My biggest concern
Electronics Forum | Thu Aug 12 17:17:47 EDT 1999 | Brian Wycoff
| | | Does anyone use reflow profilers? Are they a good investement or is trial and error sufficient? | | | | | | Does anyone have any suggestions on profiles to try? Thanks. | | | | | Danielm | | I would hazard a guess that most if not all of us
Electronics Forum | Wed Nov 04 02:53:53 EST 1998 | Earl Moon
| Micheal, | | What does your profile look like for the wave? What profile does your flux say you need? My guess is it is not your profile, our testing with solder balls found that the mask on the boards was the largest contributor to solder balls
Electronics Forum | Sat May 23 17:30:44 EDT 1998 | Steve Gregory
| My question is: How does one recognize paladium leads so that the profile can be set properly? | Dave F Hi Dave, It's kinda' subjective, but what I think it looks like is almost like having a nickel appearance to it, it's smoother and not as
Electronics Forum | Thu Nov 12 09:32:30 EST 2009 | spitkis2
Take a look at http://www.atco-us.com/products/info/3 . Benchtop version is also available. A full forced convection oven delivers much better thermal uniformity than an IR/forced air combo system. When comparing different ovens, some things to
Electronics Forum | Thu Feb 24 00:37:08 EST 2022 | joshsvoboda
I have a pcb with an ENIG finish that is using a 144 pin LQFP and being soldered withSN100C/NC258 T4 paste. I used a oven profiler where the probes are taped down to the joint and the profiling software adjusts the program for the best profile for
Electronics Forum | Tue Aug 07 08:20:47 EDT 2001 | CPI
Are there other components on the board? If so, how does solder quality look on them? Are they all reflowing? Are the sections of the uBGA�s sitting on a ground plane? Sounds like un-even heating. You should attach a couple thermal couples and see h
Electronics Forum | Fri Apr 16 08:49:07 EDT 2004 | Chris Lampron
Hi Barry, Your best course of action is to perform a thermal profile and determine exactly what the times/temps are in these locations. Try to match your profile to the recommendations of your solder paste. (Time between 130-160, Time over 183 and m
Electronics Forum | Thu Nov 01 22:04:51 EDT 2007 | davef
How does the delta T on the board relate to the delta T on the component?