Electronics Forum | Tue Sep 14 18:33:38 EDT 1999 | Mark Belec
I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts.
Electronics Forum | Fri Jun 23 09:53:40 EDT 2000 | Bob Willis
Also I suggest you read through the Charity Report I produced on the specifi process of Double Sided Reflow Assembly which you can also get from the SMTA. All the money from the sale of the report goes to the Charles Hutchins Scholarship Fund which T
Electronics Forum | Fri Jun 23 10:29:51 EDT 2000 | Bob Willis
Also I suggest you read through the Charity Report I produced on the specifi process of Double Sided Reflow Assembly which you can also get from the SMTA. All the money from the sale of the report goes to the Charles Hutchins Scholarship Fund which T
Electronics Forum | Mon Oct 04 12:18:43 EDT 1999 | RICK_EEI
Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding sold
Electronics Forum | Thu Apr 14 18:28:20 EDT 2005 | darby
We use the standard supports that come with the machine. Print a 1:1 transparency of the first pass side of the pcb including mechanical outline and components. Your customer may need to supply this. Flip this over and tape it into position at th
Electronics Forum | Wed Sep 15 06:14:16 EDT 1999 | Wayne S.
| I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | Hello, you can get some insight by typing in double sided boa
Electronics Forum | Thu Sep 23 06:01:16 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Thu Sep 23 06:06:20 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Thu Jul 15 17:53:34 EDT 1999 | Boca
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Tue Sep 22 11:20:08 EDT 1998 | S Maganti
We are getting into a lot of double sided boards offlate. Our customer is loading a lot of RNETS, Diodes ( MINLS, SOT23s and other 2 leaded diodes ). We are processing it through a traditional glue process and wave soldering the SMT parts along with
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
