Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Tue May 19 14:38:07 EDT 2020 | dnachristen
Ok still looking for a supplier for NEW belts. Not drive belts but what is seen in the picture.
Electronics Forum | Thu Oct 04 09:32:23 EDT 2007 | dilbert
Linear drive uses linear motors that have no moving parts, strictly a coil over magnets. "Rack and Pinion" as you call it uses AC servo motors that are driving belts and pullies The linear motor has no moving parts and is faster but generates a lot
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Sun Nov 07 21:00:15 EST 2010 | mainenetservices
sounds like its probably a timming belt. stock drive products is the place i go for robotics mechanical stuff, They likely have a sutable belt if you can get a good mesurement on everything(mesure the pully teeth, the belt may be streched). https://
Electronics Forum | Fri Nov 05 22:45:04 EDT 2010 | wingding
Does anyone know where to but parts for Hover Davis feeders. I need a 18 ½ x 1/8 inch drive belt for a Fuji feeder.
Electronics Forum | Thu Sep 13 06:26:01 EDT 2007 | chrispy1963
Yeah Sr., MyData is definately proud of their parts which shows in their pricing. We use outsourced parts where ever available. Belts for Ywagon tables, conveyor drive belts, ect.... We finally got a break on the tooling though! Finally found a way
Electronics Forum | Tue Jun 30 14:59:54 EDT 1998 | Justin Medernach
| Looking to contact some users of Vitronics reflow ovens. | Which model do you use? | Overall opinion of equipment and company? | Thanks in advance I use an SMR500 without inert reflow, although it's capable. I have had great success with this oven
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Mon Jul 26 11:20:40 EDT 1999 | Kevin Hussey
| | | Which among the two profiling method is more reliable/accurate in getting the oven thermal profile? | | | | | | a) using a HIGH-TEMP solder wire then soldering the thermocouples onto the profile points of the board (e.g. component lead etc.) |
