Electronics Forum | Mon Jul 13 20:24:10 EDT 2020 | emanuel
Can't find the correct part number for the conveyor belt of a DEK Europa. It is round and green, perhaps antistatic type. I found the part number of the same for 265GSX, it is 122022 G4957. Any idea if the Europa uses the same belt size as the 265GSX
Electronics Forum | Tue Nov 29 01:11:34 EST 2005 | ajay
I am looking for purchase of EKRA E4 spare from nor EKRA agent. part detail - BELT 80222B-20 L=1835MM 5011000002 Any contact pl. confirm. ajay
Electronics Forum | Thu Oct 22 22:13:20 EDT 2020 | gabriel1blue
I got new belts for the original floppy drives and installed them but the machine was reset to Japanese and after changing it back to English the drives are not running or powering up even though we can measure that the 5 volts are coming into it. I
Electronics Forum | Fri Oct 23 05:02:34 EDT 2020 | gabriel1blue
I change the settings to match another machine we have and that actually got the original drives working after replacing the belt. I ordered an adapter that will connect to the 26 pin flat cable and adapt to a 34 pin connector and pull the power from
Electronics Forum | Fri Apr 12 18:10:57 EDT 2019 | davef
Here's what we've done in the past. Depending on how it's configured, conveyors can run either forward or backward, but only in one direction at a time. The voltage polarity through the starter of the drive motor configures the direction. So, swappin
Electronics Forum | Wed Apr 24 21:45:33 EDT 2019 | aksaustin
If you look in the back of the panel there should be some type of VFD drive that controls the conveyor motor. You may be able to control rotation that way depending on the manufacturer. Should be able to google the VFD mfg and find a manual online,
Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Jan 05 21:01:40 EST 2021 | brianjones
We are looking at setting up a memory module conveyor belt with a stacker and de-stacker. I will need to handle DDR3 and DDR4 Long DIMM and SODIMM. I will be mounting an image camera under and over the modules. Looks like an edge conveyor would be be