Electronics Forum | Mon Aug 12 19:35:42 EDT 2002 | sleech
Been there, ... done that,...got the T-shirt. When with a major IC manufacturer, we tried this. IT DIDN'T WORK! The problem was that most convection ovens leak. We could not achieve a significant N2 atmosphere.Eventually went to vacuum-assisted bak
Electronics Forum | Tue Aug 06 08:54:21 EDT 2002 | mike
I have two basic questions: 1. We have a number of small convection ovens and want to modify some of these for baking out parts when needed. We have tried pumping nitrogen into these but I still run between 35 and 50 RH. Has anyone tried converting a
Electronics Forum | Tue Nov 29 12:36:13 EST 2016 | kahrpr
If you are running a no clean process why are you cleaning
Electronics Forum | Tue Nov 22 15:21:54 EST 2016 | mowens
Is there some material that can be applied to a bluetooth module to keep wash water out. We need to clean the board, however, this part is not washable. We are running a NC process. Any Ideas?
Electronics Forum | Mon May 07 15:54:22 EDT 2007 | joeherz
If you're looking for something for less than $5-10k, you should consider setting up a point-of-use air drying system. If you can supply fairly dry air from a house system to the point of use dryer, you can acheive humidty levels below 2% easily. W
Electronics Forum | Thu Dec 08 22:57:45 EST 2016 | ttheis
I'm not too experienced with this but what about an air-blast with an ionized air source such as an air knife above and below a conveyor to push most of the fluid off of the pcba then run through an oven just above vaporization temperature.
Electronics Forum | Wed Apr 12 21:04:10 EDT 2000 | Dave F
Ashok: You still didn�t tell me why you want additional drying of your boards, but what the hey, we all have our dark secrets. Anywho, let�s consider some options for reducing the moisture of your cleaned boards: OPTION 1 - Up-Grading Your Cleaner
Electronics Forum | Wed Dec 11 00:36:20 EST 2013 | aflex
Don't they have the Dry Run button/options?
Electronics Forum | Fri Oct 22 19:07:29 EDT 2010 | jry74
To get out of a delivery pinch, I had to pre-tim some connectors because of contaminated leads. Make sure your selective wave speed and XYZ travel are close. Try doing a dry run across the board to preheat the PTH and then go back and solder them.
Electronics Forum | Wed Dec 11 02:03:59 EST 2013 | haiae
I did not find anywhere in the software or button to do dry run mode, but I see one video clip in the youtube that show this machine can do it.
