Electronics Forum | Fri Jul 12 12:00:13 EDT 2024 | jdengler
How would you print 2 different products in the same line? This seems to me to be the sticking point on that approach. I don't see enough benefit of dual lane to justify the added expense. Remember you will need to have dual lane conveyors possibl
Electronics Forum | Thu Jul 04 15:02:27 EDT 2024 | tommy_magyar
I wouldn't get a dual conveyor pick and place machine unless there is a huge amount of boards to be built over a long time - like automotive industry.
Electronics Forum | Wed Jul 17 09:55:03 EDT 2024 | tommy_magyar
I agree with jdengler. Unless you have long contracts for a product (or a few similar products) to run constantly on a dual conveyor line, I don't see how this will pay off.
Electronics Forum | Sun Jul 14 21:24:23 EDT 2024 | simonattwood
There is at least one printer I've seen that takes two stencils at a time and runs them in parallel. Another has a two conveyors and will use one to pass through with the idea that you'd put two printers next to each other, feeding different sides of
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Fri Nov 17 03:41:38 EST 2023 | ravikumargv
Dear All, Any update for the below request. Please do the needful as soon as possible
Electronics Forum | Thu Mar 05 03:01:06 EST 2020 | leo_dektec
Hello toki, The only factor you need to consider is the production yield. If the volume is really high, need two smt line to run continually to meet the production, then u have no choice. If the volume is not that much, then u can consider below smt
Electronics Forum | Fri Jul 12 11:38:42 EDT 2024 | tommy_magyar
You could probably take the data of your most complex AND high runner board to the machine supplier and ask them to simulate what is the gain of the dual lane compared to the single lane. Most likely the best thing to do.
Electronics Forum | Tue Jul 30 11:43:11 EDT 2024 | sophyluo1985
Correct, you can use a dual-track pick-and-place machine, but the front-end machine must be able to meet your production, such as a printer. If you are back-to-back, what is the CPH of your pick-and-place machine? What is the size of your PCB? If po
Electronics Forum | Tue Jul 16 08:06:25 EDT 2024 | ginny
hello, sir: I have two units of MPM momentum BTB can meet your back to back configurations. if you want,Please let me know. other thing is if you can put the samsung dual lane f2 under your consideration, I'm also have some.Have a good day.
