Electronics Forum | Wed Oct 29 17:44:45 EST 2003 | adlsmt
Anyone have a manual for a model 8130 mag unloader?
Electronics Forum | Fri Jul 12 12:00:13 EDT 2024 | jdengler
How would you print 2 different products in the same line? This seems to me to be the sticking point on that approach. I don't see enough benefit of dual lane to justify the added expense. Remember you will need to have dual lane conveyors possibl
Electronics Forum | Tue Oct 11 11:52:58 EDT 2005 | chunks
Elektrobit (JOT) makes a wave unloader you can use to put your board back onto an edge conveyor (if you are using just a belt on your oven now) and then place a FIFO or Mag Loader after that.
Electronics Forum | Tue Dec 12 12:03:39 EST 2017 | dleeper
A lot of it depends on what machines you are using and how well they implement dual lane feeders. A few general comparisons: Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders Cons: -two
Electronics Forum | Wed Dec 08 20:47:01 EST 2021 | cbeneat
It's funny, we expanded with 2 additional lines a few years back. Set them up for exactly what you're saying, the end of one is 5 feet from the beginning of another. Operator would only have to pull the magazine from the mag loader, turn around and l
Electronics Forum | Fri Oct 24 13:35:11 EDT 2003 | cnotebaert
Ok, I have been trying to purchase a magazine unloader (front of line to load brds into smt equip) from 3 different used equipment manufacturers. I have been hounding them for 4-5 weeks to get me a quote. They all tell me they have them but I have no
Electronics Forum | Mon Dec 11 19:28:51 EST 2017 | spoiltforchoice
That's not really the point of dual lane feeders. As a general rule having a dual lane 8mm feeder means the machines "slots" are actually 16mm, dual lanes on a 8mm feeder helps keep the overall lane density of a machine higher, its much easier to bui
Electronics Forum | Mon Mar 02 21:54:10 EST 1998 | MONICA PARK
| Is there any publication or web-site where I can find out more information on the manufacturers of SMT and through hole equipment, the size of the market place, and the typical values of equipment? Dear. Sir. We are so pleased to contact with you
Electronics Forum | Mon Mar 02 21:57:35 EST 1998 | MONICA PARK
| | Is there any publication or web-site where I can find out more information on the manufacturers of SMT and through hole equipment, the size of the market place, and the typical values of equipment? | Dear. Sir. | We are so pleased to contact wit
Electronics Forum | Wed Dec 13 01:14:02 EST 2017 | tsvetan
"Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders" none of these is true for Sony SI-G200 machines we have dual lane feeders are bigger than the standard 8 mm feeders so no space savin
