Electronics Forum | Mon Apr 09 14:53:19 EDT 2007 | flipit
Hi, We were running with few defects with lead solder paste. The lead solder paste with stencil 0.010" X 0.020" and 0.004" thick stencil produced near defect free PCB assys. 0.010" X 0.020" (0.004" thick) lead = defect free 0.010" X 0.020" (0.005"
Electronics Forum | Tue May 08 10:39:42 EDT 2007 | realchunks
Well, in manufacturings defense, I have to say we LIKE our AOI. We run preset-up jobs that are scanned in by the operators. The bar code on each reel is placed there from incoming. Incoming is a very, very busy place. From time to time we find th
Electronics Forum | Thu Apr 26 10:07:06 EDT 2007 | realchunks
Hi Dub J, I have worked for a few companies that did 3D sampling and found the data they produce to be useless. In the real world they are slow, so that means you won't sample every board. Now if you're not sampling every board, and you start to r
Electronics Forum | Thu May 10 17:33:05 EDT 2007 | bkgsmtnet
Thank You Mark!. I appreciate your time. I have contacted them for a demo. Looks like they only handle the quoting aspect. I am also looking for Scheduling, Order, Inventory management suggestions. There has got to be a software that you can define y
Electronics Forum | Tue Jun 12 14:29:01 EDT 2007 | realchunks
You'll need to calibrate your effectiveness to the deliverables of the adhsive quality and initiate the description of the criteria for requirements by developing a framework for the application architecture consistent with the planning corridor spec
Electronics Forum | Wed Jun 13 15:56:35 EDT 2007 | ck_the_flip
I experienced this with a high-mass capacitor. I was able to turn down the bottom-side convection (around 50�C lower than each of the top-side heaters), and able to NOT lose any parts. I got the bottom-side part just slightly over liquidus, and min
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Mon Jul 30 15:28:25 EDT 2007 | gmoritz
I'm posting a diary of the major repair experience that we had this weekend. I'll follow up with a shorter post that sort of summarizes a few things. ------------------------------------------------ The service guys showed up at our facility about
Electronics Forum | Mon Aug 06 14:05:02 EDT 2007 | slthomas
BEC hardware would be on the machine as a sensor underneath the placement table, to the left of the C&C, and an emitter attached to a bracket to the left of the insert head. The two line up with each other and the sensor uses a quadrant layout to det
Electronics Forum | Sat Aug 11 15:59:10 EDT 2007 | bentigano
Hello cuculi. I was actually the guy you sent the .pl file to a while back to help me out with the .800 program optimization. Speaking of which, the Perl code reminded me a lot of PHP, and was extremely helpful, so thanks again. Hopefully I'll be ab